Heatmiser 8 Zone Underfloor Wiring Center

$254.70 inc GST
Heatmiser 8 Zone Underfloor Wiring Center


The HMUH8 is an 8 Zone wiring centre for use with Heatmiser Neo thermostats. It can control any actuator or valve which requires a 230v AC signal while offering the ability to operate a boiler or other heat source through a volt free output. Additional outputs designed for use with underfloor heating systems are also included as standard. These are the pump and valve outputs which would normally operate a manifold pump or a manifold valve. Zone 8 can be used as an isolated radiator zone by using the UFH/RAD switch.

If the switch is set to RAD; When zone 8 calls for heat this will provide an output to a radiator zone valve and the boiler, but WILL NOT enable the underfloor heating pump/valve output.
If the switch is set to UFH; When Zone 8 calls for heat, this will act as an underfloor heating zone, by enabling the actuator, boiler and pump/valve outputs.
Any output which is not needed can be ignored.

HMUH8 installation manual

Download (396.6 kB)

HMUH8 spec sheet

Download (354.9 kB)

Troubleshooting knowledgebase

Our Troubleshooting knoweldge base is only available to installers and technications.

Try logging back in with another account.

Waterware Connect

Latest releases, important info, no garbage  


Please select which newsletter(s) you'd like to subscribe to

© 2019 Waterware.
Auckland web design by Fuel